Installing your mats correctly

1. Start with a clean floor

Before installation, ensure the floor is clean, dry, and free of debris. A clean surface improves mat stability and prevents premature wear.

2. Place your mats correctly

Roll out your mat or assemble your modular system directly in the working area. Make sure the mat fully covers the operator’s natural standing zone.

3. Ensure the mat does not move

A mat that shifts can create serious trip hazards. Always verify that the mat lies flat, remains stable, and stays in position during normal use.

4. Use safety ramps only where needed

Safety ramps are designed to reduce trip risks at open edges. They should be used only where users enter or exit the mat.

Important:

Where mats are installed against fixed equipment, such as workbenches or machines, safety ramps are not required. Ideally, the mat should extend approximately 15 cm underneath the workbench, allowing users to stand comfortably close to their task without imbalance caused by feet extending beyond the mat edge.